Hello All,
I've had this Alfa for awhile now>
http://s181686668.onlinehome.us/phpBB3/ ... ca220119f6It's been put off due to family problems. I'm now ready to make a start on building her. I would like to go the Compressed air system and use trim tanks as per the subs on here.
The Boat is 80" x 9" After speaking with Andy about this
Thanks for the link Andy.
I'm now looking at using 200mm kg tube if i can squeeze it in.
I've received very accurate plans from Russia, Which sadly show the boat to be inaccurate, However given that this hull was produced in the nineties information was scarce. All i can do is try to transfer as much detail as possible onto Hull.
I really need some Help/Guidance with this Air compressed setup as i have never utilised this system before.
How it goes together whats required where to source commercial parts, The usual questions a new guy has.
I look forward to any comments, suggestions
Kindest regards
adam