Pressluftjunkies.net http://forum.pressluftjunkies.net/ |
|
O-ring for piston tank http://forum.pressluftjunkies.net/viewtopic.php?f=14&t=225 |
Seite 1 von 1 |
Autor: | Cedric Meyer [ 29. März 2007, 17:33 ] |
Betreff des Beitrags: | O-ring for piston tank |
Autor: | Lothar Mentz [ 29. März 2007, 19:33 ] |
Betreff des Beitrags: | |
Autor: | Cedric Meyer [ 30. März 2007, 01:24 ] |
Betreff des Beitrags: | and for the closure rings?? |
Thanks for that super fast answer, yes, i understand! Well i was really wrong then! And i did the same mistake for the alu rings, hopfully, i did not start to turn them! The inner diameter of the PVC tube is 219 and i bought O-rings type 200 X 5! I thought that the O-ring should be compressed (so that it had to be bigger) to insure a water tight tube! If i understansd i should buy something a little smaller as well. Do you have an idea of wich O-ring sascha uses? Sscha, if you read that post... Thank you. |
Autor: | Lothar Mentz [ 30. März 2007, 08:13 ] |
Betreff des Beitrags: | |
Hi Cedic, as far as I know, the outside Diameter is 219. The thickness is about 4 mm. So the inner diameter is about 210. I would buy O-Rings of 196x5 or so... Than the outer Diameter of the Ring is 206mm ok? Lothar |
Autor: | Sascha Hornbach [ 30. März 2007, 12:45 ] |
Betreff des Beitrags: | |
Hi, the Rings I use are 196x5 like Lothar said. |
Autor: | Cedric Meyer [ 30. März 2007, 12:50 ] |
Betreff des Beitrags: | |
i wrote the message a little too fast, yes, 219 is the outer dimension, i checked the caracteristic of the PVC tube this morning: inner diameter is 209, 5mm thick. Hum, i can't use a 200 X 5 O-ring then... Too big! OK, thanks for the tip, next time, before buying something, i will ask before. Thank you very much. |
Autor: | Mario Weide [ 30. März 2007, 19:05 ] |
Betreff des Beitrags: | |
Hallo Cedric, Für den Kolbentank babe ich 65 X 2,5 mm verbaut Da der Kolben nur 10 mm breit ist, war es einfacher in der Reihenfolge 1,5 mm Rand- 2,5 mm - O Ring - 2 mm Rand - 2,5 mm - O Ring - 1,5 mm Rand zu drehen. Gruß Mario |
Autor: | Alexandre Gillon [ 31. März 2007, 09:34 ] |
Betreff des Beitrags: | |
Bonjour Cédric J’ai pour toi 6 O-Ring de 70X2 mm. C’est ce que j’ai dans mes pistons. A+ Alexandre |
Seite 1 von 1 | Alle Zeiten sind UTC + 1 Stunde [ Sommerzeit ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |